Electronic product development · Northern Italy
I design custom PCBs, write embedded firmware and bring up boards on the bench. My work covers industrial instruments, mechanisms and space hardware, including integration with sensors, actuators and the wider system.
Scope of work
I work on controller boards, measurement electronics and embedded systems. Assignments include new designs, changes to existing products and investigation of faults on prototype hardware.
I consider the board alongside its firmware, wiring, power supply and mechanical constraints. At the bench, I use measurements and diagnostic code to isolate faults and check the next revision.
Architecture, schematic & PCB
Embedded control & interfaces
Bring-up, measurement & debugging
Selected work
Controller electronics for a docking mechanism and a portable measurement instrument. Each record describes my contribution and the resulting hardware.
ENSYS · Portable instrumentation
I designed the electronic architecture and PCB for a compact, battery-powered instrument, reproducing an existing laboratory measurement setup with local logging and Bluetooth connectivity.
Read project record →
Stellar Project · Small-satellite systems
I supported Stellar Project in developing a controller-board engineering qualification model representative of the flight unit’s form, fit and function. My scope covered electronic design, firmware, bring-up and integration support.
Read project record →Capabilities
Architecture, component selection, schematic design, PCB layout and prototype revisions.
Microcontroller firmware for sensing, actuation, communications, control logic and diagnostics.
Board checks, diagnostic firmware and bench measurements to isolate power, clock and interface faults.
Interface definition and testing across controllers, sensors, motors, displays and mechanical assemblies.
Analysis of existing hardware and firmware before replacing unavailable components or migrating functions.
Investigation of technical issues, prototype testing and documentation for subsequent revisions.
Working method
I agree the interfaces and constraints first, then check the decisions that need evidence from hardware.
Document the required behaviour, power budget, interfaces, mechanical envelope and existing hardware.
Use calculations, evaluation boards or focused tests to check component and architecture choices.
Check supplies, reset and clocks, then exercise interfaces with diagnostic firmware and bench instruments.
Document measurements and faults, make the changes and repeat the relevant checks.
About
I am an electronics and embedded systems engineer based in Northern Italy. I work with companies across Italy and Europe on new electronic designs, existing-product modifications, prototype bring-up and technical investigations.
When a project needs expertise in adjacent disciplines, I work with a network of professional specialists.
Contact
Send me a short description of the product, its current stage and the engineering work you need. I work with companies across Italy and Europe.
Useful starting points: existing hardware, required interfaces, known faults and the next development milestone.